Brand:

Serpent

Product Type:

Gas Cars > 1/10 235mm

Set fixed wheel axles for front and rear. This set replaces the quick-change release system and can be built into the standard 4-WD wheel axles of Impact 2 and M2 all Specs. Improves wheel stability and handling.

Related products

• - Wheelflanges alu. F+R (2+2) (#808331)

Wheel Shims

It is important to note the Difference in Spacing of the shims as per picture. The bigger spaced shim goes on the rear with the smaller space goin to the front.

Front Wheel Adaptors -  Step 1

Press the inside bearing into the steering block
The wheel axle should be in place before putting the aluminium spacer in.
Press the outside bearing in place.

Step 2

Place the 16x10mm spacer on the wheel axle
Put the aluminium-mounting shaft into the wheel axle, and press in the 17mm long pin.
Tip: Screw the 5mm into the aluminium-mounting shaft to make it easier to position the hole for the pin.

Step 3

Place the wheel over the wheel axle
The mounting washer can now be mounted, but it may be necessary to use the supplied 10x5mm shims to get rit of any play.
Tip: if you're sure how many shims to use, glue them in the mounting washer to secure them in place, with silicone sealant or similar product.

Rear Wheel Adaptors  - Step 1

Press the inside bearing into the up-right
The wheel axle must be in place before putting the aluminium spacer in.
If the spacer is not free, you should cut the flat inside edges of the upright away. This is due to the shock mounting grubscrew pushing plastic in the way of the spacer. This is visible on a used upright but on a new upright the grubscrew should be put in place so the plastic can be cut away before continuing. This could be done with a sharp knife or dremel tool.
Press the outside bearing in place.

Step 2

Place the 16x10mm spacer on the wheel axle
Put the aluminium-mounting shaft into the wheel axle, and press in the 17mm long pin.
Tip: Screw the 5mm into the aluminium-mounting shaft to make it easier to position the hole for the pin.

Step 3

Place the wheel over the wheel axle
The mounting washer can now be mounted, but it may be necessary to use the supplied 10x5mm shims to get rit of any play.
Tip: if you're sure how many shims to use, glue them in the mounting washer to secure them in place, with silicone sealant or similar product.